Installing auto glass rope

Category: Uncategorized. I always wanted to install using the rope-in method over the lip-in because it was less likely that breakage would occur during installation. The edge of the glass was protected by the gasket that was attached to the edge before the glass was placed into the opening. The rope-in method requires that the glass and gasket be removed and re-installed as an assembly and not two separate parts. I highly recommend that if you can rope-in rather than lip-in, it would be to your best interest to do so.

It is easier and safer for the vehicle, glass and technician. Next week will be the lip-in installation method. Why do you seal between the glass and the gasket after installation? Lubricant and adhesive contacting the same bonding surface is a risky proposition, since the former will compromise the effectiveness of the latter. Particularly, in the case of an installation where it is impossible to seal the gasket after the glass and gasket have been roped in; how do you suggest one would properly negotiate around this dilemma, to preserve the integrity of the adhesive bond to the pinchweld?.

The lubricant is smeared on the inner lip of the gasket. It only contacts the inner lip of the pinchweld. This is not the point of seal for the gasket. Many first-time restorers are surprised that installing a windshield can be one of the most frustrating parts of a restoration. In the episode, Rick gives several tips for installing a windshield successfully, including planning the steps in advance, enlisting the help of other crew members and preparing yourself for the fact that it may take some time -and a little elbow grease- to get the job done right.

Take a long cotton rope or string — thin, about the size of the string on window blinds — and drench it completely in a mix of water and dish soap.

Leave about six inches of soapy string free at the start and take it to the inside of the vehicle. Leave about six inches at the finishing end, too. The two 6-inch ends become handles to pull. Now work with your helpers to put the windshield into place, with one person putting pressure on the outside top of the windshield and someone else working from the inside of the vehicle, pulling one end of the rope gently until rubber pops through.

Made in the USA, this Equalizer auto glass installation tool is very useful to have in your body shop or garage. By using this website, you agree to our use of cookies to analyze website traffic and improve your experience on our website.

Learn More. Description Reviews The Equalizer Rope Insert Tool is specially formulated for installing locking gaskets on windows and other glass parts of automobiles.